[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [Rollei] unsubscribe
- Subject: Re: [Rollei] unsubscribe
- From: Marc James Small <msmall >
- Date: Mon, 24 Jun 2002 18:39:09 -0400
- References: <C32D66E0EFABD111BF8400805FE65D6108B8C7E4 >
At 06:06 PM 6/24/02 -0400, B. D. Colen wrote:
>
BD
Here's how to unsubscribe:
First, ask your Internet Provider to mail you an Unsubscribing Kit.
Then follow these directions.
The kit will most likely be the standard no-fault type. Depending on
requirements, System A and/or System B can be used. When operating System
A, depress lever and a plastic dalkron unsubscriber will be dispensed
through the slot immediately underneath. When you have fastened the
adhesive lip, attach connection marked by the large "X" outlet hose. Twist
the silver- coloured ring one inch below the connection point until you
feel it lock. The kit is now ready for use. The Cin-Eliminator is activated
by the small switch on the lip. When securing, twist the ring back to its
initial condition, so that the two orange lines meet. Disconnect.
Place the dalkron unsubscriber in the vacuum receptacle to the rear.
Activate by pressing the blue button. The controls for System B are
located on the opposite side. The red release switch places the
Cin-Eliminator into position; it can be adjusted manually up or down by
pressing the blue manual release button. The opening is self- adjusting. To
secure after use, press the
green button, which simultaneously activates the evaporator and returns the
Cin-Eliminator to its storage position. You may log off if the green exit
light is on over the evaporator . If the red light is illuminated, one of
the Cin-Eliminator requirements
has not been properly implemented. Press the "List Guy" call button on the
right of the evaporator . He will secure all facilities from his control
panel.
To use the Auto-Unsub, first undress and place all your clothes in the
clothes rack. Put on the velcro slippers located in the cabinet immediately
below. Enter the shower, taking the entire kit with you. On the control
panel to your upper right upon entering you will see a "Shower seal"
button. Press to activate. A green light will then be illuminated
immediately below. On the intensity knob, select the desired setting. Now
depress the Auto-Unsub activation lever. Bathe normally. The Auto-Unsub
will automatically go off after three minutes unless you activate the
"Manual off" override switch by flipping it up. When you are ready to
leave, press the blue "Shower seal" release button. The door will open and
you may leave. Please remove the velcro slippers and place them in their
container.
If you prefer the ultrasonic log-off mode, press the indicated blue button.
When the twin panels open, pull forward by rings A & B. The knob to the
left, just below the blue light, has three settings, low, medium or high.
For normal use, the medium setting is suggested. After these settings have
been made, you can activate the device by switching to the "ON" position
the clearly marked red switch. If during the unsubscribing operation, you
wish to change the settings, place the "manual off" override switch in the
"OFF" position. You may now make the change and repeat the cycle.
When the green exit light goes on, you may log off and have lunch. Please
close the door behind you.
- --------------------
Marc
msmall FAX: +276/343-7315
Cha robh bàs fir gun ghràs fir!
------------------------------